Each train has two cars that can hold six riders each for a total of twelve riders per train. The roller coaster operates with seven stadium-style seating X-Car trains. Throughout the layout of the roller coaster, there are 6 sets of brakes to control the speed of the trains. Also, the track is filled with sand and gravel to reduce the noise when a train is on the track. Because the lift hill is vertical, a special evacuation system is used in the event that a train stalls on the lift. The steel track of Hollywood Rip Ride Rockit is 3,800 feet (1,200 m) long, and the height of the lift is approximately 167 feet (51 m). Finally, the train drops once more, travels over a small hill, and then enters the final brake run as the song playing ends. An s-bend turn follows, which leads the train into an inclined loop and a fourth set of brakes. Following a small drop to the left, the track straightens for a moment before making a right turn, a left turn, and then another right leading into the third set of mid-course brakes. This is followed by a large dip that takes the train into a second set of mid-course brakes. Next the train enters a quick element nicknamed "The Jump Cut", a non-inverting corkscrew. It drops back down, going through a hole in a wall before entering a left, upward helix section of the coaster that is nicknamed "The Treble Clef". The train then enters a non-inverting loop nicknamed "The Double Take", followed by an upward right turn into one of the several mid-course brakes. When the train reaches the top of the lift, it drops back to the ground, reaching a maximum speed of 65 miles per hour (105 km/h). The on-ride video recorder also begins recording. After the restraints are checked, the train immediately begins to climb the 167-foot (51 m) vertical chain lift, and the song selected by the rider begins to play. Riders have approximately 30 seconds to take their seat, lower the lap-bar, and make their song choice. There is a moving sidewalk on both sides that moves at the same speed as the train allowing riders to board. The station for the roller coaster is a unique design, in which trains enter and slow down but do not stop. In the video, characters called "Video DJ's" are used as demonstrators to provide a visual explanation. #Hollywood rip ride rockit how toIn each of the queue lines, there are several large screen displays that explain how to pick a song to play during the ride and important safety instructions. Lockers are provided for storage of these items. Riders must pass through a metal detector in order to board, and may not board with any loose items on their person or in pockets. Guests first enter into one of three queues either the main queue, the express queue, or the single rider queue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |